003 Making Plastic Explosives from Bleach

Published in

· 4 years ago

  

Making Plastic Explosives from Bleach           by The Jolly Roger 

Potassium chlorate is an extremely volatile explosive compound,  
and has been used in the past as the main explosive filler in  
grenades, land mines, and mortar rounds by such countries as  
France and Germany.  Common household bleach contains a small  
amount of potassium chlorate, which can be extracted by the  
procedure that follows. 

First off, you must obtain: 

[1]  A heat source (hot plate, stove, etc.) 
[2]  A hydrometer, or battery hydrometer 
[3]  A large Pyrex, or enameled steel container (to weigh  
     chemicals) 
[4]  Potassium chloride (sold as a salt substitute at health and  
     nutrition stores) 

Take one gallon of bleach, place it in the container, and begin  
heating it.  While this solution heats, weigh out 63 grams of  
potassium chloride and add this to the bleach being heated.   
Constantly check the solution being heated with the hydrometer,  
and boil until you get a reading of 1.3.  If using a battery  
hydrometer, boil until you read a FULL charge. 

Take the solution and allow it to cool in a refrigerator until it  
is between room temperature and 0 degrees Celcius.  Filter out the  
crystals that have formed and save them.  Boil this solution again  
and cool as before.  Filter and save the crystals. 

Take the crystals that have been saved, and mix them with  
distilled water in the following proportions:  56 grams per 100  
milliliters distilled water.  Heat this solution until it boils  
and allow to cool.  Filter the solution and save the crystals that  
form upon cooling.  This process of purification is called  
"fractional crystalization".  These crystals should be relatively  
pure potassium chlorate. 

Powder these to the consistency of face powder, and heat gently to  
drive off all moisture. 

Now, melt five parts Vaseline with five parts wax.  Dissolve this  
in white gasoline (camp stove gasoline), and pour this liquid on  
90 parts potassium chlorate (the powdered crystals from above)  
into a plastic bowl.  Knead this liquid into the potassium  
chlorate until intimately mixed.  Allow all gasoline to evaporate. 

Finally, place this explosive into a cool, dry place.  Avoid  
friction, sulfur, sulfides, and phosphorous compounds.  This  
explosive is best molded to the desired shape and density of 1.3  
grams in a cube and dipped in wax until water proof.  These block  
type charges guarantee the highest detonation velocity.  Also, a  
blasting cap of at least a 3 grade must be used. 

The presence of the afore mentioned compounds (sulfur, sulfides,  
etc.) results in mixtures that are or can become highly sensitive  
and will possibly decompose explosively while in storage.  You  
should never store homemade explosives, and you must use EXTREME  
caution at all times while performing the processes in this  
article.  

You may obtain a catalog of other subject of this nature by  
writing: 

     Information Publishing Co. 
     Box 10042 
     Odessa, Texas  79762