Modernz 58

eZine lover (@eZine)

Published in 

Modernz

 · 5 years ago

  

                        --=* EZ Napalm *=-- 

                          By Neuromancer 

 

 
Disclaimer: 

The information contained in this file is intended for information purposes 
only.  The author is not responsible for the use/misuse of this information. 
Once it is in your hands I urge you to use it responsibly.  Please share this 
file with your friends and distribute it widely. 

 

Creating the mixture: 

Here is a cheap and easy way to make yourself a very effective napalm 
substitute.  You'll need gasoline, styrofoam, and a pail.  I use a metal 
pail, but anything that can hold up to gasoline is good.  Start with 
enough gasoline to cover the bottom of the pail about a half inch deep. 
Then start adding the styrofoam.  The gasoline will sort of soak it up. 
Just keep adding more and more styrofoam, putting it in slowly, waiting for 
it to be absorbed by the gasoline, until it wont soak up any more.  It will 
take quite a bit of styrofoam, so make sure you have alot on hand.  When 
the gasoline stops soaking up the styrofoam it's done.  Pour off the 
mixture into a glass jar for storage. Avoid getting the mixture on your 
skin because it will cause serious irritation.  Wash your hands when you're 
through to avoid getting it into your eyes, etc.  Voila!  You have some 
napalm. 

 

Practical application: 

The mixture can be used as a throwing weapon.  To make a neat little 
projectile take a glass bottle and score the outside with a glass cutter in 
a checkerboard pattern.  Pour the mixture into the bottle.  Put a gasoline 
soaked rag into the neck of the bottle.  Light the rag and throw the bottle. 
The reason for the scoring is to make the bottle break easily on impact, 
so that when it is thrown the mixture spreads into a wide radius and gets 
ignited by the burning rag.  This stuff does a nasty job on car paint... 
just pour it onto your victim's car and light.  For a neat timed ignition 
system, see below.  If you used the right amount of styrofoam this stuff 
will burn for a looooong time leaving much expensive damage in it's wake. 

 

Neat timed ignition system: 

To make this you'll need a cigarette, matches, and some masking tape.  Take 
about a 2 inch length of tape and lay it down flat.  Line up matches side by 
side perpendicular to the length of the tape, covering about half <fig.1>. 

 
             ooooooooooooo 
             |||||||||||||----------------| 
            /|||||||||||||----------------|\ 
           / |||||||||||||                  \ 
          /_ matches                         \_ tape 

                     Fig. 1 
                     ------ 

Wrap the tape/matches around the cigarette so the match heads are about an 
eighth of an inch up from the filter.  You can spread the mixture on whatever 
it is you are going to be burning and lay the igniter so that the cigarette 
is away from the mixture and the matches are just at the edge.  Light the 
cigarette first!  It will take some time for the head of the cigarette to 
reach the matches, thus igniting them, thus igniting the mixture.  It takes 
some practice to get the placement right, but when you have it down it gives 
you time to get away.  I actually got this idea from the news.  It was used 
by an accomplished arsonist in setting gasoline fires.  Isn't the media 
wonderful? 

That's all for now.  Above all, have fun! 

peace, 
Neuromancer